Press use common trouble causes and Solutions
1, the sieve cloth oil mill plantgo unilateral. When the examination, if it is not equal to screen surface horizontal level, should be adjusted so that the length of the screen body; if the emergence of torsion, adjustable eccentric shaft to the frame vertical. If it belongsto the stone screen surface oil go unilateral, can adjust the level of machine frame; if the air is not uniform, which can adjust the air regulating plate, so that the uniform airflow blows to the screen surface. If the screen net rate is low, should be replaced with new brush or brush length adjustment, adjust the tilt angle of the flat screen.
2, not to mention the material belt at. The main reason is, bucket elevator convey or lower oil mill accumulated too much, causing blockage, can open the conveyor lower door,clear the accumulation of oil.
3, on a steaming pot billet uneven. When the examination, if the dryer steam jet hole plug or rust, should clear the steam jet holes. If it is blank in the middle and lower thepaste pot, adjustable scraper and the distance; if the scraper twisted wear, replace the scraper; if it is blank cooking cooked unevenly, should adjust the limit switch,contactor and floating plate, so that the motor coordination.
4 roller does not rotate, overload. Exclusion method: start between rolls if there is oil,can loosen the roll adjusting bolts, remove roll oil; if they are feeding too much too fast, the feeding opening inserting plate closed; if the thickness of billet rolling out of uneven, nuts should be re adjust the roll gap, tighten the loose.