How to improve the oil yield oil processing

Before using the press, first of all should be ready aids and containers , check and adjust the belt tightness . Then start the motor , the machine empty running around 15min, check the speed of the pressing screw shaft. Average speed should be around 33dmin. Do you want to pay attention to when idling gear box gear meshing and sound normal, whether nmb oil equipment and motor parts properly. When press idling , the motor current should be about 3A. If the current is too high , you should immediately stop checks, adjustments and then boot.
After the load is normal, around 50kg ready rapeseed or soy , ready to put into the hopper . Note: When you start squeezing feed not too fast, otherwise the sudden increase in pressure within the bore virgin , virgin not turn the screw shaft , causing blockage virgin bore , even to squeeze cage rupture, a major accident . So at the beginning of the compression , the seed oil press be evenly slowly into the hopper , so press be run together . So repeatedly , sustained more than 3 ~ 4h , so press the temperature gradually increased , and even take smoke ( this is normal ) . At the start of the press virgin bore low temperature, can be slowly twist the handle on the withered section stud , increase the thickness of the cake , while improving water into juice billet , to be squeezed bore temperature. Rose to about 90 ℃, the normal operation of the press , the cake thickness can be adjusted to 1.5 ~ 2.5mm, and tighten the nut tightened.